Products Search:
Chinese | English

Products Catalogue
Test monitor
UTP Video Balun
Surge protector
Video anti-interference device
Video ground loop isolator
BNC connector
IR illuminator
Housing
Controller
Bracket
Pan/Tilt
Quad processor
Video converter
Intellegent keyboard
Cable series
Power supply
Video Weighted Amplifier
VGA UTP Transmitter

Products  >> CCTV accessories >> Surge protector


AJ3-12
12V DC 3 in 1 power video and data surge protector for cctv system
 
 
Feature
1)  International famous core component brand
2)  High discharge current capacity, superior transmission performance, no leakage current
3)  Multi stage protective circuit of camera power, PTZ control and video cable
4)  Small size, easy installation
5)  Low residual voltage, good protecting effect
6)  Quick response, stable performance, reliable working
 
Specification
Product model
AJ3-12
1. power SPD specification
Max continuous working voltage (Uc)
12VDC
Nominal discharge current (In)
10KA
Max discharge current (In)
20KA
Protection level
≤100V
2. signal SPD specification
 
Video
PTZ control
Max continuous working voltage (Uc)
12
12
Nominal discharge current (In)
5KA
Max discharge current (In)
10KA
Protection level
≤25V(core wire—case/ground)
Data transmission rate
≤100Mbps
Impedance
75Ω
Insertion loss
≤0.5dB
Interface type
BNC-K/J
2P terminal
3. other specification
Case
Aluminum material, oxidation surface(black, silver)
Dimension
110*61*28mm (including interface)
Wire interface
Power supply
Compression joint port, suitable for 16-26AWG(0.15-1.3mm²) wire
Control signal
Video signal
BNC connector
Ground
Earth wire terminal or 2.5mm²earth wire
Installation
Inside of box or cabinet
Working conditions
Temperature:-40~+85℃; Relative humidity:≤95%(25℃); Elevation≤3km
 
 Installation and wiring
1)  According to protection demands, the SPD is connected by series between protected devices and signal path,
the closer the distance to protected devices, the better the protection effect.
2)  To connect separately a)the cable to the input terminal of power, video and control port, b) output terminal of
SPD power, video and control to related interface of protected devices, c) ground line of SPD to earth wire of
lightning protection system
3)  After wiring, please check it until everything is going well, to put into operation.
 
Product maintenance 
1)  The product does not need to be maintained specially, but to inspect at fixed period, especially before and d
uring thunderstorm season.
2)  Once there is a failure during system operation, please remove the SPD device at first, if the system can
operate normally, the device is broken


  粤ICP备14091515号